Connecting Wires to the Speaker Selector
CAUTION: Please make sure your amplifier or receiver is turned off before proceeding.
The Removable Terminal Connectors simplify connecting the speaker and amplifier wires to the Speaker Selector.
(See Diagram 2)
For best results, use speaker wire that is at least 16 gauge. For runs longer than 75 feet, 14 gauge wire is recommended. For best
results, strip all wire insulation no more than
3⁄8
" from the end before inserting into the connector.
1. Remove the Terminal Connectors from their locations on the back of the cabinet. This will make it easier to connect the wires.
(See Diagram 3)
2. Connect the wires from the speakers to the appropriate location under “SPEAKERS” on the removable terminals. Please observe
proper polarity (+, –) of the connections.
(See Diagram 3)
3. Insert the wired terminal connector into the appropriate speaker output on the back of the speaker selector.
4. Connect the amplifier or receiver speaker output to the appropriate location under ”AMPLIFIER” on the removable terminal.
Please observe proper polarity (+, –) of the connections.
(See Diagram 3)
5. Insert the wired terminal connector into the amplifier input on the back of the speaker selector.
Continuous
Protection
AMPLIFIER
L+ L- R- R+
SPEAKERS
L+ L- R- R+
SPEAKERS
L+ L- R- R+
SPEAKERS
L+ L- R- R+
SPEAKERS
L+ L- R- R+
Amplifier
Input
Off On
Speaker
Output
4
Speaker
Output
3
Speaker
Output
2
Speaker
Output
1
Removable Terminal Connectors
for Speaker Wire
Removable Terminal Connector
for Wires from Amplifier or Receiver
Continuous
Protection Switch
SPEAKERS
L+ L-
R- R
+
STEP 1.
Strip speaker wires’ insulation to
3/8" from the end and insert into
proper slot in the Speaker
Terminal Connector.
STEP 2.
Tighten wire clamp screw
with screwdriver.
STEP 3.
Install Speaker Terminal
Connector into back of the
Speaker Selector.
STEP 4.
Connect Amp wires to the
Amplifier Terminal Connector
in the same manner.
SPEAKER WIRE
Diagram 3
Diagram 2
2
