Profi Cook PC-MS 1032, Instruction Manual

Page: 33 / 62

33
Cleaning
WARNING:
• Always pull the power supply plug before
cleaning.
• Allow the appliance to cool down.
• Never immerse the base in water for clean-
ing. It could result in an electric shock or fire.
CAUTION:
• Do not use a wire brush or other abrasive
items.
• Never use sharp or scouring cleaning materi-
als.
Base
Clean the base with a clean cloth from the outside,
without any additional cleaning agents.
Jug, lid and mixing attachments
• Always clean the jug, the lid and the mixing at-
tachment immediately after use.
• Remove the used mixing attachment from the
jug by pulling it upwards.
• Only rinse the parts by hand with a soft cloth
while adding a mild dishwashing detergent.
• You may remove ingrained dirt with a nylon
brush.
• Then rinse with clean water and dry off the
parts.
• Stow the mixing attachments in the compart-
ments on the underside of the base so that they
do not get lost.
Storage
• Clean the device as described and allow to dry
completely.
• We recommend that you keep the appliance in
the original packaging if the appliance will be
not used for long periods.
• Always keep the appliance out of the reach of
children in a dry, well ventilated place.
Troubleshooting
Malfunction
Possible
Cause Remedy
The appli-
ance does
not work/the
motor does
not turn
Does the jug
stand properly on
the base?
Check if the jug
is properly placed
on the base.
Is the appliance
switched on?
Try a different
socket.
Is the mains
socket defective?
The milk
doesnot
foam
Is frothing at-
tachment “2a”
properly attached
Check the attach-
ment.
Is the attachment
blocked?
Is there too little
milk in the can?
There should be
between 75 and
225 ml in the
can.
The appli-
ance turns
off before
the allotted
time during
repeated hot
stirring or
frothing
The appliance
has not cooled
down.
Leave the ap-
pliance to cool
down for
2 minutes.
You may shorten
this time by rins-
ing the jug with
cold water.
Technical Data
Model: ...................................................PC-MS 1032
Power supply: ............................230 - 240 V~, 50 Hz
Power consumption: .............................. 600 - 650 W
Protection class: .......................................................Ι
Net weight: .......................................approx. 1.08 kg
The right to make technical and design modifica-
tions in the course of continuous product develop-
ment remains reserved.
This device complies with all current CE directives,
such as electromagnetic compatibility and low volt-
age directive and is manufactured according to the
latest safety regulations.