CLEANING & USE GUIDANCE
1.
Clean the inner liner, ice collecting tray, water box, ice shovel and
evaporator frequently. When cleaning, unplug the unit and remove the
ice cubes. Use a diluted solution of water and vinegar to clean the inside
and the outside surface of the Ice maker. Do not spray Ice maker with
chemicals or diluted agents such as acids, gasoline or oil. Rinse
thoroughly before starting.
2.
Keep ventilation openings in the appliance enclosure, or in the built-in
structure, clear of obstruction. Do not use mechanical devices or other
means to accelerate the defrosting process, other than those recom-
mended by the manufacturer.
3.
Reuse the machine after being idled for a period of time, it may not have
enough water to pump for air retard, and the indicator of “ADD WATER”
will keep lighting. At this time, you just need to press POWER button
again, the machine can enter normal state.
4.
To ensure the cleanness of ice, please change water for water reser-
voir at least once one day. If do not use for a long time, please drain
the water out and clean it up.
5.
If the compressor takes a strike action for shortage water, fully water or
interruption of power supply, it will delay for 3mins to start up after
restarted.
6.
Always use fresh water before starting ice production either at initial
installation or after a long shut-off period.
TROUBLESHOOTING
1. Please note, if a power failure occurs due to disconnection of the power cord,
or the power button has been pushed off during an ice making cycle, small ice
chips may form and lodge in the automatic shovel causing it to jam. If this
occurs, the ice chips may be removed by disconnecting the power cord and
gently pushing the shovel to the rear of the cabinet and removing the ice
chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not remove
the ice to ice basket. If not, please push the ice shovel gently by finger, then
press POWER button to restart.