IMPORTANT: This manual includes essential
information on the safety measures to be
implemented for installation and start-up. Therefore,
the installer, as well as the user, must read these
instructions before beginning installation and start-up.
To achieve optimum performance, follow the
instructions indicated below:
1. VERIFY THE CONTENTS OF THE PACKING:
The following items are included inside the box:
• Plastic Models 170PC/170PW
• Lamp Assembly x 1
Lamp Assembly x 1
• Underwater cable gland x 1
Underwater cable gland x1
• Stainless steel screws x 2
• Stainless steel screws x 2
• Roll plugs x 2
• Roll plugs x 2
• Heat shrinks x 2
• Heat Shrinks x 2
• Silicone tubes x 2
Silicone tubes x 2
• Rubber Insets x 2
2. GENERAL CHARACTERISTICS AND INFORMATION:
• This is an underwater light; and must be used/
operated while fully submerged underwater only.
•
This lamp is designed to be fixed in new pools
and/or pools with existing surface mounted
lamps that need replacement.
• This lamp is designed to be used only once.
Should it become defective, repair is impossible,
and replacement is necessary.
•
This lamp will not fit into a PAR56 niche.
• In order to clearly illuminate a pool it is
recommended to install one of these lamps for
every 10-15m² of water surface.
• The manufacturer is not responsible in any
circumstances for assembly, installation or start-
up of any electric components that have been
inserted or handled at locations other than its
own premises.
3. MAINTENANCE & REPLACEMENT:
There is no maintenance required for this lamp
– it is designed to be used only once, meaning
replacement is necessary if it becomes defective
(repairing is impossible).
Before any handling, ensure that there is NO voltage
supplied to the lamp. To replace, remove the two
rubber inserts using a small flathead screwdriver and
unfasten the two stainless steel screws.
Ensure the new lamp is of the same model and
characteristics as the one being replaced. In order
to ensure full water-tightness, clean the seat of the
cable gland and fully tighten the nut.
4. START-UP:
• Ensure that the voltage going into the lamp is
never greater than 12V.
• The lamp should only operate underwater while
secured to the vertical walls of the pool. Never
switch on the lamp if it is not underwater.
•
To achieve synchronization, confirm all lamps are
installed correctly, switch on lights, hold for 10
seconds, switch off for 5 seconds, and then finally
turn them on again. Repeat until all lights are in
sync.
•
In case of colored lamps, 16 pre-programmed
effects and combinations may be selected using
the on/off switch of your pool lights.
• Alternatively, we recommend using our optional
step-down transformer which comes with (a)
remote control for easy operation and (b) two
auxiliary connection for operation of any other
electrical item.
5. SAFETY WARNINGS:
• The persons who are in charge of installation
should have the required qualifications for this
type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding
accident prevention.
•
IEC 364-7-702 standards must be observed:
WIRING IN BUILDINGS, SPECIAL WIRING,
SWIMMING POOLS.
• Lamp replacement must be performed with
the lamp disconnected from the electric power
system.
• Do not handle any electrical components with
wet feet.
6. TECH SPECS:
Input Voltage: 12V
Output Wattage: 18W (RGB) & 20W (Double White)
Number of bulbs: 288 total (RGB 96 each color &
Double White 144 each color)
Life: Approximately 50,000 hours
7. MORE INFORMATION:
For more information on this product, installation
guides and maintenance procedures, please visit
www.propoolpro.com
Professional Pool Products reserves the right to alter this document as
and when necessary, without prior notice.
