26
LAMP ADJUSTMENT
The lamp-holder is aligned at the factory. Due to differences between lamps,
fine adjustment may improve light performance.
Open the shutter, set the dimmer
intensity onto 100% and direct the light
on a flat surface (wall for example).
Center the hot-spot (the brightest part of
the beam) using the two adjustment
screws “A” and “B”. Turn one screw at a
time to drag the hot-spot diagonally
across the projected image. If you cannot
detect a hot-spot, adjust the lamp until
the light is even.
RIGGING
DANGER TO LIFE: Please consider the respective national norms during the
installation. The installation must only be carried out by an authorized dealer.
The installation must always be secured with a secondary safety attachment, e.g.
an appropriate catch net. This secondary safety attachment must be constructed
in a way that no part of the installation can fall down if the main attachment
fails.
When rigging, derigging or servicing the fixture staying in the area below the
installation place, on bridges, under high working places and other endangered
areas is forbidden.
The operator has to make sure that safety-relating and machine-technical
installations are approved by an expert before taking into operation for the first
time and after changes before taking into operation another time.
The operator has to make sure that safety-relating and machine-technical
installations are approved by an expert after every four year in the course of an
acceptance test.
The operator has to make sure that safety-relating and machine-technical
installations are approved by as killed person once a year.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including
(but not limited to) calculating working load limits, installation material being
used, and periodic safety inspection of all installation material and the
