4
been attached to the wing in factory. Before gluing the aileron servo, center the servo horn
by means of a servo tester or with a receiver/ transmitter. Install the servo with epoxy and
balsa wood block if necessary. Mark the horn insertion and cut a 5mm slot in the aileron and
epoxy the control horn. Connect the linkage wire to the servo horn.
Try fitting the wings to the fuselage with the wing joiner and the 3mm carbon rod. Adjust and
orient the joiner such that both wings are in perfect position. 5mm holes can be drilled on the
sides of the fuselage to pass the wires of the aileron servos. Drill two 3mm holes on the
fuselage to connect the carbon rods, that strengthen the wing against torsion.
The wing joiner is made of fiberglass and this guarantee no risk of wing breakage at high
velocity. Sand all contact surfaces to maximize bonding strength.
Glue the main wings with epoxy, then tape the wings firmly to the fuselage. Support the wing
with blocks if necessary. Check for horizontal and longitudinal symmetry.
Main Wing
Main Wing