PRODEM PDS 030R, Operating Instructions Manual

Page: 28 / 48

www.prodem-attachments.com
CONNECTIONS
INSTALLATION
28 Translated by the original
SPECIFIC CONNECTION TECHNIQUES
HYDRAULIC CONNECTIONS
Attachment A B Operating Machines
Power
Rotation
Drainage
B optional B optional B optional
PDS Range
A A A B B B
3/8"
Gas 3/8"
Gas
S 16 (M24x1,5)
1/4"
Gas 1/4"
Gas
L 12 (M18x1.5) / / / PDS 030R
3/4"
Gas 3/4"
Gas
S 25 (M36x2)
3/8"
Gas 3/8"
Gas
S 16 (M24x1.5) / / /
PDS 050R - PDS 070R
PDS 120R
1" SAE
6000 1"
Gas
S 30 (M42x2)
3/8"
Gas 3/8"
Gas
S 16 (M24x1.5) / / /
PDS 200R - PDS 250R
PDS 300R - PDS 400R
PDS 500R
1"1/4
SAE
6000 1"1/4
SAE
6000
1"1/4 Gas
1/2"
Gas 1/2"
Gas
S 16 (M24x1.5)
1/4"
Gas 1/4"
Gas
L 12 (M18x1.5) PDS 550R
1"1/2
SAE
6000 1"1/2
SAE
6000
1"1/2 Gas
1/2"
Gas 1/2"
Gas
S 16 (M24x1.5)
1/4"
Gas 1/4"
Gas
L 12 (M18x1.5) PDS 700R– PDS 900R
1"1/2
SAE
6000 1"1/2
SAE
6000
1"1/2 Gas
3/4"
Gas 3/4"
Gas
S 25 (M36x2)
1/2"
Gas 1/2"
Gas
S 16 (M24x1.5) PDS 1600R
The pressure and flow output by the operating machine must always be that prescribed for the attachment in
use (see Table 3.5.1 Technical Data). If this is not the case, the system must be equipped with reduction valves
(contact the manufacturer of the operating machine or a specialized workshop).
Do not use the attachment without check that the pressure and oil flow of the operating machine are those
required.
Before using the attachment start the operating machine and slow put the hydraulic system under pressure to
avoid hammers, until the maximum operating pressure is set, which should conform to the specifications
shown on the identification plate of the attachment. With the motor at the minimum, open the attachment to
1/4 and close, open to half and close, open to 3/4 and close and, finally, open completely and close. Open
and close the attachment 5 or 6 times, check that there are no leaks along the hydraulic circuits.
ATTENTION!
Before using the attachment for demolition, bring it to an open space free of obstacles and without
persons in the range of action of the operating machine and perform several maneuvers empty to
familiarize yourself with the attachment.
At this point, the attachment can be used for work.
Table. 4.6.1