prodelin C-Band Rx/Tx, Assembly Manual

Page: 12 / 13

4096-417
C-BAND Rx/Tx
PRODELIN CORPORATION ODU FEED INSTALLATION
12
LINEAR FEED ASSEMBLY AND INSTALLATION
Refer to the following table for item and part numbers for these steps.
STEP 1: Assemble the ODU to the Tx port of the feed assembly (item #1) with the
disc and spacer, as shown in figure 4. Place the gasket (supplied with
ODU between the feed and ODU flanges. Use the 2 short #10 screws
(item #4) in the top 2 holes, and the 6 long #10 screws (item #5) through
the disc and spacer. Use lockwashers and flatwashers (item #6,7) as
shown. Tighten securely.
STEP 2: Attach LNB to OMT with 1/4-20 x 1.00” screws, flatwashers, lockwashers
and nuts (item# 8,9,10,11). Tighten securely.
STEP 3: Place the completed feed assembly on the support bracket, with the neck
of the feed horn in the feed mounting bracket, and the disc on the inside
of the angle. Secure with the top feed mounting bracket (item # 12) using
[2] 5/16-18 x 1.00” bolts, [2] lockwashers, and [2] 5/16-18 hex nuts (item #
14, 16,17).
STEP 4: Slide the angle against the radio mounting disc. Tighten the 3/8”
hardware to prevent sliding. Install the 5/16-18 x .75” bolts, flatwashers
and lockwashers (item# 13,15,16) from the inside of the angle. Tighten
securely after desired polarization is achieved.