PRODA MEDIPRO MP-AH, Manual

Page: 5 / 28

TECHNICAL SPECIFICATIONS
Rating voltage: 220-240 V @ 50/60 Hz 30 W
Water Tank Capacity Approx. 1.6 l
Run Time Per Tank Min. 4.5 hours (at max. evaporation)
Evaporation quantity max. 350 ml/h
Noise Level < 37 dB from 1 m away
Swichable color LED light
BEFORE EACH USE
• CHECK HUMIDIFIER PLACEMENT
Place the Humidifier on an elevated, non-metallic, lint-free, waterproof,
level surface at least 2 feet above the floor.
• DO NOT PLACE ON CARPET OR TOWEL. The fan vent is located on the
bottom of the humidifier base. The fan vent MUST NOT be obstructed.
• DO NOT PLACE ON WOOD SURFACE or near furniture that can be
damaged by too much moisture.
• CHECK WATER LEVEL SENSOR: Make sure the Water Level Sensor is secured properly and not obstructed.
CAUTION
• DO NOT attempt to operate the humidifier without water in the Water Tank.
• DO NOT plug or unplug the Power Cord with wet hands as electric shock could occur.
ASSEMBLY & USE
ALWAYS use fresh cool water when operating the humidifier.
1. Turn Water Tank upside down, unscrew Water Tank Cap and fill with cool water only.
ALWAYS HOLD WATER TANK WITH TWO HANDS WHEN FULL.
• DO NOT fill water all the way to the rim. DO NOT use hot water.
•
DO NOT
add any medication, essential oils, or salt. DO NOT pour water into Mist Lid.
2. Screw Water Tank Cap back onto Water Tank and turn the tank over to place on Humidifier Base,
making sure it fits together securely.
•
Note:
Do not attempt to move the humidifier while full Water Tank is placed on the Humidifier Base. Doing so may cause
leakage of water and/or Humidifier Base to overfill.
3. Plug the power cord into a wall socket and turn on the unit by using the Control Dial.
4. The Power Indicator Light will illuminate in green indicating that there is enough water in the Humidifier Base and mist will
begin emitting through the Mist Lid.
5. Use the Control Dial to adjust the intensity of the mist output.
SET THE CORRECT HUMIDITY OUTPUT: Adjust the Control Dial so the mist rises up to be absorbed by the room air.
If mist drops quickly, turn down the control knob until the mist is rising up.
6. When the humidifier runs out of water, the Power Indicator Light will turn red and the mist output will stop.
This is a safety feature to prevent the humidifier from possibly overheating and damaging the Nebulizer.
Turn the humidifier off and unplug the unit before removing and refilling the water tank. When emptying the base,
be sure to pour away from the fan outlet.
EN