ProCurve 3500yl Series, Management And Configuration Manual, Page: 150 / 732

6-38
Switch Memory and Configuration
Multiple Configuration Files
Figure 6-25. Example of Clear + Reset Result
Transferring Startup-Config Files To or From a Remote
Server
TFTP: Copying a Configuration File to a Remote Host
For example, the following command copies a startup-config file named test-
01 from the switch to a (UNIX) TFTP server at IP address 10.10.28.14:
ProCurve(config)# copy config test-01 tftp 10.10.28.14
test-01.txt unix
Command Page
copy config < src-file > tftp < ip-addr > < remote-file > < pc | unix > below
copy tftp config < dest-file > < ip-addr > < remote - file > < pc | unix > below
copy config < src-file > xmodem < pc | unix > 6-39
copy xmodem config < dest-file > < pc | unix > 6-40
Syntax: copy config < src-file > tftp < ip-addr > < remote - file > < pc | unix >
This is an addition to the copy tftp command options. Use
this command to upload a configuration file from the switch
to a TFTP server.
For more on using TFTP to copy a file to a remote server, refer
to “TFTP: Copying a Configuration File to a Remote Host” on
page A-25.
Pressing Clear + Reset:
– Replaces all startup-config files with a single
file named config1 that contains the default
configuration for the software version in
primary flash.
– Resets the Active, Primary, and Secondary
assignments as shown here.
3500-5400-6200-8200-MCG-Jan08-K_13_01.book Page 38 Monday, January 28, 2008 10:04 AM