ProCurve 10ag, Installation And Configuration Manual, Page: 21 / 132

2-1
2
Installing the Access Point
This chapter provides information on the requirements for installing the
access point and guides you through the steps required for the proper instal-
lation of the device.
Topics covered include:
■ Before You Begin
■
Installation Precautions
■ Installation Procedures
Before You Begin
Before starting with the installation, make sure that you have the required
items for the installation ready. In addition, verify that the wireless clients and
devices on the network have the required components for wireless communi-
cation with the access point.
Installation Requirements
To install the access point, you need the following:
■ Access point
■
Power adapter (included in the access point package) or PoE switch
■ Ethernet cable
If the default IP address 192.168.1.14 is not compatible with your network
settings, you will need to change it before you can set up the access point. To
change the IP address, you will need to connect a computer with TCP/IP and
a 10Mbps or 100Mbps network interface card directly to the access point.
The access point is managed through a browser-based interface. You will need
a common Web browser to access the management interface.