Page 16
- 10 -
8. Welding with remote control
When the pedal switch is used to control, connect the 7-core aviation plug with the 7 socket.
The remote control green indictor(2) will be on, it is automatically recognized when you plug in,
adjust the knob(11) “Welding current”, it can set the maximum current when you press the foot
pedal to the maximum, the current display(3) will show the setting current. The digital display
shows the actual welding current when using foot pedal to control the welding.
WARNING !!
- During the welding of alternating current (AC) with low current values, the formation of oxides
on the surface of the tungsten electrode occurs. This can cause problems with arc ignition. In this
case, the electrode should be rubbed against the material being welded or otherwise mechanically
cleaned of the tip of the electrode from the oxide layer.
- Do not operate the button more than 2 mm from the welded material.
ground cla
mp
workpiece
TIG weld
ing torch
Gas
cylinder
Ar meter