www.usaprocom.com
19
200047-01A
WARNING: You must oper-
ate this heater with the screen
in place. Make sure screen is
installed before running heater.
NOTICE: During initial operation of
new heater, burning logs will give
off a paper-burning smell. Orange
flame will also be present. Open
damper or window to vent smell.
This will only last a few hours.
1. STOP! Read the safety information,
page 17.
2. Install two AAA size batteries in the remote
control (see page 21).
3. Be sure the slide switch on the front of the
receiver box is in the REMOTE position.
4. Make sure equipment shutoff valve is fully
open.
5. Push in control knob slightly and turn
clockwise
to the OFF position.
6. Wait five (5) minutes to clear out any gas.
Then smell for gas around heater and near
the floor. If you smell gas, STOP! Follow
"B" in the safety information, page 17.
If you do not smell gas, go to the next step.
7. Push in control knob slightly and turn
counterclockwise
to the PILOT
position. Press in control knob for five (5)
seconds.
MODEL PCSD25RT
LIGHTING INSTRUCTIONS
Ignitor
Button
Control Knob
Receiver
Figure 19 - Ignitor Button and Control
Knob Locations
OPERATION
THERMOSTAT CONTROL OPERATION
The thermostatic control used on this model differs from standard thermostats. Standard ther-
mostats simply turn the burner on and off. The thermostat used on this heater senses the room
temperature. At times the room may exceed the set temperature. If so, the burner will shut off.
The burner will cycle back on when room temperature drops below the set temperature. The
control knob can be set to any comfort level between Low (1) and HIGH (5).
Shutting Off Heater
Turn control knob clockwise
to the
OFF position.
Shutting Off Burner Only (pilot
stays lit )
Turn control knob clockwise
to the
PILOT position.
1. Follow steps 1 through 5 under
Lighting
Instructions
, page 18.
2. With control knob in PILOT position, strike
match, and hold near pilot. Press in control
knob; pilot should light.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
4. Make sure the heater screen is in place
before operating heater.
TO TURN OFF GAS TO APPLIANCE
MANUAL LIGHTING PROCEDURE
