Procom ML170EHPC, Owner'S Operation And Installation Manual

Page: 19 / 28

19
TROUBLESHOOTING
Continued
REMEDY
1. Ventilate room. Stop using odor
causing products while heater
is running
2. Locate and correct all leaks(see
Checking Gas Connections,
Page 10)
1. Open window and/or door for,
ventilation
2. Contact local propane/LP gas
company
3. Clean ODS/pilot (see Cleaning
Page 14)
1. Locate and correct all leaks(see
Checking Gas Connections,
Page 10)
1. Remove foreign matter.
2. Locate and correct all leaks
(see Checking Gas
Connections, Page 10)
1. Refer to Air for Combustion and
Ventilation requirements , Page
5
POSSIBLE CAUSE
1. Heater is burning vapors from
paint, hair spray, glues, etc.
(See IMPORTANT statement
at beginning of troubleshooting)
2. Gas leak. See WARNING
Statement at beginning of
troubleshooting
1. Not enough fresh air is available.
2. Low line pressure
3. ODS/pilot is partially clogged
1. Gas leak. See WARNING
Statement at beginning of
trouble
shooting
1. Foreign matter between control
valve and burner
2. Gas leak See WARNING
Statement at begining of
troubleshooting
1. Not enough combustion/
ventilation air
OBSERVED PROBLEM
Heater produces unwanted odors
Heater shuts off in use (ODS
operates)
Gas odor exists even when heater is
shut off
Gas odor during combustion
Moisture/condensation on windows
NOTE: BEFORE YOU SWITCH TO “ ELECTRIC ” CONTROL LEVEL FROM MANUAL CONTROL, YOU NEED TO
TURN THE KNOB TO “ OFF ” LEVEL FIRST AND WAIT FOR ONE MINUTE, THEN TURN THE KNOB TO “ ELECTRIC ” .
IN CASE OF “ ELECTRONIC ” CONTROL LEVEL DOES NOT WORK, PLEASE TURN THE CONTROL KNOB COUN-
TERCLOCKWISE TO “ OFF ” LEVEL AND WAIT FOR ONE MINUTE.