www.usaprocom.com
3
200498-01A
SIZING THE FIREPLACE HOOD TO THE FIREPLACE OPENING OR
GLASS DOOR FRAME
ASSEMBLY INSTRUCTIONS
The fireplace hood assembly is adjustable
from 28" to 48". The hood assembly must
be opened wide enough to cover the entire
fireplace opening. The hood can be opened
wider if desired. Fore best appearance, make
sure center section of the hood assembly is
centered with the fireplace opening. Follow
the instructions below to properly size the
fireplace hood assembly.
1. Measure width of fireplace opening or
glass door frame (see Figure 1). Use
work space below to figure proper size
for fireplace hood.
Measurement "A"__________________
Subtract 24"
(width or hood center section) _________
Subtotal = _______________________
Divide by 2 ______________________
Measurement "B"__________________
Measurement "B" is the distance from
the outside edges of the adjustable
outer-hood assembly sections (see Fig-
ure 2). When adjustable outer sections
are extended to this measurement, hood
assembly will be correct size. The overall
width of the hood assembly will equal
the width of the fireplace opening. If you
have glass doors and would like the hood
assembly to hang beyond the edge of the
door frame, add 1/2" to measurement "B".
Make sure that the hood provides room
for opening doors.
2. Place center-hood section face down on
a smooth, soft surface.
3. Measure in from the outside ends of the
adjustable outer-hood sections. Place a
piece of tape on the bent-under flange
of the adjustable outer-hood sections to
mark the distance of measurement "B"
(see Figure 3).
4. Slide the adjustable outer-hood sections
into center section. Stop when the edge
of the center-hood section is even with the
tape (see Figure 4). Place pieces of tape
across adjustable outer-hood sections
and center-hood section to hold in place.
IMPORTANT: Tape must be removed before
operating the fireplace.
Measurement ”A”
Fireplace Opening
Measurement ”A”
Glass Door Frame
Measurement ”B”
Adjustable Outer-Hood
Sections
Center-Hood
Section
Figure 2
Figure 3
Figure 4
Figure 1
Tape
Adjustable Outer-
Hood Sections
Measurement ”B”
Edge of Center-
Hood Section
