Proceq Zehntner ZRM 6013+, Instruction Manual

Page: 49 / 76

version 1.1
ZRM 6013+
Instruction manual Menu
last update: 30.07.2014 page 49
The backwards counting wet timer can be set between
2 and 1
’000 seconds.
In the mode “Single” the wet timer will be deactivated
after each measurement. This is shown after the
measurement on the display in the measure mode by
the icon .
In the
mode “Continuous” the wet timer will remain
activated also after a measurement has been taken.
This is shown in the display in the measure mode by
the icon .
14.4.2 Interval timer
Path: ->
and selecting “Timers”
Here you can activate the interval mode. By this
continuous measurements will be taken. The interval
timer can be used e.g. to define the performance of
the retroreflection of a marking in dependence on the
effluent water at wet measurements. The
measurements will be taken continuously until the
indicated number of interval counts has been reached.
If the interval timer is activated, you can see the
current setting for the interval time and interval counts.
For changing these settings, you need to press the
respective line.