Seite 37
11 Maintenance and cleaning
11.1 Maintenance and cleaning work that can be carried out by the user
Only the following maintenance and cleaning work shall be carried out by the user:
•
Outer cleaning of the apparatus (see chapter 11.2 on page 37)
•
Periodical lubrication of the guide shafts (see chapter 11.3 on page 37)
•
Replacing of the fuse (see chapter 11.4 on page 39)
•
Inspection (see chapter 11.5 on page 39)
All other maintenance and repair work shall only be carried out by
Proceq SA
or your authorized Proceq agent otherwise all guarantee and liability claims
are void.
11.2 Cleaning
In order to ensure a perfect function, the film applicator should be kept as clean as
possible. Remove eventual stains of coating materials or adhesives immediately
before they can dry. Later they can often only be removed with difficulty.
For cleaning of the
apparatus
use commercially available cleaning agents such as
cleaning agent for glass, benzine, acetone. Do not use strong acids or alkaline
liquids!
For cleaning of the
printing blanket
use only cleaning agents which do not affect
the printing blanket. Unsuitable for this purpose are solvents containing ketone such
as acetone, or nitro-cellulose diluents.
Before cleaning the Proceq ZAA 2600, always switch off the apparatus and
unplug it. Never immerse the apparatus in water or other liquids: Danger of
short circuit.
While cleaning, take care that no cleaning liquid penetrates the interior of the
apparatus. The function of electrical or mechanical components could be
impaired.
The edge of the printing blanket of the glass plate must not get wet.
If the device has to be disinfected, do not use disinfectants that contain
sodium hydroxide.
Never touch the hot plate, always wait until the heating plate has cooled.
11.3 Lubrication of the guide rods
From time to time it can be necessary to lubricate the guide rods with some sewing
machine oil or something similar.
