•
Specifications subject to change. | ©2022 Procella Audio Svenska AB, Procella Audio USA, LLC. All rights reserved. | V1.0 2022/11
Maintenance
After operating for some time, if the airflow and cooling become
less effective, please turn off the amplifier. Remove and clean the
dust filter and clean this filter.
2.5 DSP functions
•
The input delay of each channel is 30ms, the output delay is
20ms, and the step is 0.01ms
•
Audio input level ma - 18db
•
4x4 audio route mixing, mixing ratio - 80dB ~ + 18db
•
8-segment input parametric EQ, 5-segment output parametric
EQ, high-low pass filter
•
Support FIR filters of order 512 and below
•
Volume, mute, phase adjustment, mode selection
•
Output average, peak voltage limiter
•
Parameter saving / retrieval between machines
•
Speaker parameter configuration
•
User / Debug / Factory permission setting
3. Carton Contents
The DA08-DSP amplifier is shipped in a cardboard carton
containing the amplifier unit, a mains cable appropriate for the
sales territory and a document pack.
The full contents are listed below:
•
Procella DA08-DSP amplifier
•
Mains power cable
•
Adhesive rubber feet x 4
•
Document pack
4. Installation
The installation and equipment rack should be configured to
provide appropriate ventilation airflow space around the front and
rear of the amplifier as illustrated
Diagram 1b
. A ventilation airflow
space of at least 25 mm (1 inch) should be maintained along at
least one side of the amplifier at all times. Ventilation apertures
are located on the rear panel of the amplifier and must not be
obstructed. It is important to retain at least 80 mm (3.1 inch) free
space for airflow behind the amplifier rear panel.
The amplifier works in a 0°C~40 environment. Airflow goes from
the front of the amplifier (ventilation holes) through the rear panel
to ensure effective heat dissipation. Please ensure that the air can
flow from the front to rear panels.
Note
:
If the internal temperature exceeds 85 degrees C, the output
voltage will be reduced, to avoid excessive temperature rise. If the
temperature continues to rise to 90 degrees C, the power amplifier
will shut down. Once the temperature has dropped to a safe
temperature, the amplifier will restart automatically.
Overview
Diagram 1b
