PROCEED PCD 3, User Manual

Page: 17 / 28

17
Basic operation
In this section, you’ll learn how to:
■
Load a CD;
■
Play all tracks on a CD;
■
Begin play with a track other than the first track;
■
Replay a track;
■
Skip to another track;
■
Find a particular passage on the CD;
■
Begin play in the middle of a track;
■
Suspend play using pause ;
■
Repeat an entire CD; and
■
Stop play.
To load a CD for play:
1. Turn the power on by pressing standby . The Display will light and
show " 0
0
0
00
."
2. Press drawer to open the drawer.
NEVER hold onto the drawer while it’s in motion (either opening or
closing). If you accidentally prevent the drawer from opening, wait
about three seconds, then press
drawer twice to open it.
3. Load a CD into the drawer, label side up. Handle the CD by the
outer edges only; if necessary, support it with your index finger at
the center hole.
4. Close the drawer by pressing drawer again.
Note: If you accidentally prevent the drawer from closing, it will
open again after about three seconds. Press drawer again to close
it.
In a few seconds, the Display will show the total number of tracks
and their total playing time. The CD is now ready for play.
To play all tracks on a CD, press play . All tracks will play in order. Play
will stop automatically at the end of the CD.
To begin play with a track other than the first track:
1. Before pressing play , press next until the number of the desired
track shows on the Display. If you pass the track you want to play,
you can “back up” by pressing
prev .
You may also select the track using the numbered buttons on the
Remote Control.
Loading a CD
PRECAUTION
Playing all tracks on a CD
Beginning play with a track
other than the first track