probst SG-80-PGL2-A, Operating Instructions Manual

Page: 57 / 70

Maintenance and care 25 / 26
V10 GB
7.2 Trouble shooting
ERROR CAUSE REPAIR
The clamping-power is not big enough,
the load is slipping out
(optional) The grippers are worn Replace the grippers
(optional) The maximum load is exceed Reduce the weight of. the load
(Adjustment of the gripping range)
(optional)
The actual opening width is not correct
Adjust the gripping range according to
the load you want to transport
(Property of material)
The surface of the material is dirty or
the material is not suitable / allowed for
this device.
Check the surface of the material or ask
the manufacturer, if you the material is
allowed for this device.
Unbalanced load
The device is not loaded symmetrically Adjust the position of the load
(Adjustment of the gripping range)
(optional)
The adjustment of the gripping range is
not symmetrical.
Correct the adjustment of the gripping
range
Automatic release does not work
mechanical (optional) Automatic release does not work
Clean automatic release with high
pressure-cleaner
Correct faulty switching (
→
see chapter
“Picture of the automatic release”)
Change the inset of the automatic
release
7.3 Repairs
Only persons with the appropriate knowledge and ability are allowed to repair the device.
Before the device is used again, it has to be checked by an expert.
7.4 Safety procedures
•
It is the contractor’s responsibility to ensure that the device is checked by an expert in periods of
max. 1 year and all recognized errors are removed (
→
see DGUV regulation 1-54 and DGUV norm 100-500).
•
The corresponding legal regulations and the regulations of the declaration of conformity must be
observed!
•
The expert inspection can also be done by the manufacturer Probst GmbH.
Contact us at:
service@probst-handling.com
•
We recommend affixing the inspection sticker "„Sachkundigenprüfung / Expert inspection" in a clearly
visible place (order no.: 2904.0056+Tüv sticker with year number) after the inspection has been done.