7
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
6
Visit
www.probrite.com/install
for installation video tutorials and product support
☐
If necessary, strip 3/8" of insulation from
junction box or fixture (A) wires (fig 1).
☐
Thread the wire through the domed cover
plate of the junction box (not provided) or
landscape post (not provided).
☐
Make wiring connections into the junction
box or post by following the wiring
instructions below.
ON/OFF Wiring (Non Dimming) Method:
☐
Connect fixture black wire to house black
wire, the (+) line, and fixture white wire
to house white wire, the (-) common by
twisting the exposed wires together and
using the wire nuts (BB). Ensure no loose
wires.
☐
Connect house ground wire to the green
fixture ground wire, by twisting the
exposed wires together and using the
wire nuts (BB).
3
Making the electrical connections
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
GROUND
BLACK
WHITE
GREEN
BB
0-10V Dimmable Wiring Method:
☐
Connect fixture black wire to house black wire,
the (+) line, and fixture white wire to house
white wire, the (-) common by twisting the
exposed wires together and using the wire nuts
(BB). Ensure no loose wires.
☐
Connect house ground wire to the green
fixture ground wire, by twisting the exposed
wires together and using the wire nuts (BB).
☐
Connect the purple wire to the (V+) DIM
wire and the gray wire with (V-) DIM wire by
twisting the exposed wire together and using
the wire nuts (BB).
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
(+)DIM V+
BLACK
WHITE
PURPLE
GROUND
GRAY
YELLOW
GREEN
(-)DIM V-
(fig 1).
TIP:
Hold stripped ends near each other and align any
frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your fingers
to twist the wire nut clockwise until tight. Check for
tightness by pulling wires.
Installation (continued)
Installation (continued)
4
Securing the fixture and
adjusting orientation
☐
Secure the fixture to junction box or landscape
post by inserting the threaded swivel knuckle
mount (C) into the cover plate or landscape
post. (Fig. 1)
☐
Place the locking washer on the inside of the
domed cover plate and tighten the fixture to
the plate
☐
If applicable, plug all unused holes and seal
threads with silicone.
☐
Loosen the screw on swivel portion of the
knuckle (C) using the provided allen key (CC),
adjust the fixture to a suitable orientation, and
then tighten the screw (D). (Fig. 1)
TURN PAGE
For Operation Instructions
D
C
(fig 1).
Tighten the
knuckle handle
here and use
the lock
Loosen the
screw here
to adjust the
orientation and
tighten it back
