Zelos
™
Twin 36
1.
Remove the canopy from the hull.
2.
Install the receiver antenna in the antenna tube.
3.
Install the fully charged batteries in the compartment
and secure them with the hook and loop straps.
4.
Power on the transmitter. Ensure the throttle is not
reversed and the throttle trim is neutral.
5.
Connect the battery to the ESC.
6.
Keep the throttle at neutral and power on both ESCs
simultaneously by pushing and holding the power switch
for 2 seconds.
• Once armed, the ESC will beep and the LED will flash,
indicating the number of battery cells it has detected.
• 1 short beep will sound and the LED will turn solid
when the ESC is ready to run.
The ESCs are joined with a Y harness, ensuring that only
one ESC powers the receiver. If the ESCs are powered
on one at a time, the receiver may not power up. The
secondary ESC will beep and the LED will flash every 3
seconds until the primary ESC is armed. The LED will turn
solid when the ESC is armed.
7.
Install the canopy on the hull.
Getting Started
1.
Power off the ESCs by holding the power buttons for 2
seconds and then releasing them.
2.
Power off the transmitter.
3.
Disconnect and remove the battery from the boat.
4.
Drain water from inside the hull using the drain plug.
5.
Fully dry the inside and outside of the boat, including the water
cooling lines and jacket around the motor.
6.
Remove the canopy before storage or moisture may allow mold
and mildew to grow in the boat.
7.
Repair any damage or wear to the boat.
8.
Lubricate the flex shaft using Pro Boat® Marine Grease
(DYNE4200 or DYNE4201) (see,
Drivetrain Lubrication
).
NOTICE:
Never store the boat without greasing the
flex shafts or they may rust.
9.
Make note of lessons learned from the trimming of your boat,
including water and wind conditions.
NOTICE:
Never leave the boat in direct sunlight or in a hot, enclosed area such as a car. Doing so can damage the boat.
When You Are Finished
During the first run, we recommend calm wind and water
conditions to ensure that the boat is properly set up.
Maximum speeds of 60 MPH/+ can be achieved once you
have set up the boat for your specific conditions.
Consult local laws and ordinances before choosing a
location to pilot your boat.
1.
Carefully place the boat in the water.
2.
Operate the boat at slow speeds near the shoreline. Avoid
objects in the water at all times. When the boat is moving
forward, ensure water flows out of the coolant outlet.
3.
Once you are comfortable operating the boat at slow
speeds, it is safe to operate the boat farther from the
shore at higher speeds.
4.
When making turns, decrease the throttle to reduce the
probability of flipping the boat over.
5.
Bring the boat back to shore when the motor starts to
pulse.
NOTICE:
Never operate your boat in less than 12 inches
(30.5 cm) of water.
Boating Tips
X2
1
2
3
2
2
3
4
2
5
6
1
7
6
EN
Summary of Contents for Zelos Twin PRB08021
Page 14: ...Zelos Twin 36 Notes 47...
