Owner’s Manual
Receiver Battery Installation
1.
Remove the 2 clips and lid from the battery
compartment.
2.
Install the battery in the battery compartment.
3.
Connect the battery EC3™ connector to the ON/OFF
switch.
4.
Install the lid on the box and secure the lid using the
clips.
IMPORTANT:
After boating, always remove the battery
before transporting or storing the boat.
Antenna Tube Installation
1.
Remove the 3 clips and 2 lids from the boxes.
2.
Remove the set screw using a 1.5mm hex driver and
the antenna tube from the side of the radio box.
3.
Feed the antenna through the antenna mount and into
the antenna tube as shown.
4.
Install the tube in the antenna mount, then secure the
tube with a 3mm set screw using a 1.5mm hex driver.
5.
Replace the lids and clips on the boxes.
6.
Guide the antenna tube through the hole in the
canopy and install the cap on the antenna tube.
IMPORTANT:
The antenna must be installed above
the boat’s waterline to get the best reception of your
transmitter’s signal.
Charging the Receiver Battery
Instructions
Choose a charger designed to charge the included 7.4V
5200mAh 2S 15C LiPo. We recommend the Dynamite®
Prophet Sport LiPo AC Balance Charger (DYNC2005).
Refer to your charger manual for charging instructions
and safety information.
NOTICE:
Never charge a battery in the boat or
damage may result.
5
EN
