7
Operate your Miss Elam Brushless EP in low to medium wake
conditions to avoid having problems with the boat overturning.
You may also turn the dual rate dial down to reduce rudder travel in
rough water conditions.
Steering Dual Rate
Section 7: Handling Adjustment
Section 8: Maintenance
Before and at the end of each run, make sure all screws are tight and
the propeller is free from any entanglement.
The ESC in your Miss Elam Brushless EP is preprogrammed from the
factory. The programming is set for Ni-MH batteries as shipped with
your Miss Elam.
A programming module (PRB3311) is available to change the
programming of your speed control. Settings include Ni-MH or Li-Po
batteries, cutoff voltage settings, cutoff type, brake on or off, motor
timing and throttle curve. The brake and motor timing adjustments can
be adjusted without the programming module. See the ESC
instructions for details.
NOTICE:
It is imperative that you do not attempt to use Li-Po
batteries in the Miss Elam Brushless unless it has been properly
programmed or serious damage to the batteries and electronics
may occur.
Section 9: Speed Control Programming
