Impulse
™
31
Antenna Tube Installation
1.
Carefully feed the end of the receiver antenna through
the grommet inside the hull.
2.
Pull the antenna wire out of the grommet
towards the outside of the boat, then slide the
antenna through the antenna tube.
3.
Insert the tube into the grommet, then
fit the cap onto the tube.
4.
Apply clear tape to the antenna, grommet
and hull in the boat to keep the antenna
from moving.
The antenna must be installed above the boat's waterline
to get the best reception of your transmitter's signal.
NOTICE:
Do not cut or kink the receiver antenna
or damage may result.
Boat Stand Assembly
1.
Attach the side stand pieces to the end pieces as
shown.
2.
Use medium CA or epoxy adhesive to secure the side
stand to the ends.
3.
Allow the adhesive to dry before placing your boat on
the stand.
4
EN
Recommended Tools and Materials
• Needle nose pliers
• Paper
towel
• Rubbing
alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 4mm, 5.5mm, 8mm
• Phillips screwdriver: #1
• Hex wrench: 1.5mm, 2mm, 2.5mm, 3mm
• Clear tape (DYNM0102)
• Pro
Boat
®
Marine Grease and Gun
• Hook and Loop Tape Set, WP 4pcs
