9
SECTION 3—ASSEMBLY
WARNING
After
ANY
adjustments, repair or service and before use, make sure
that all attaching hardware is tightened securely - otherwise injury or
damage may result.
ASSEMBLING THE RECLINER
WARNING
Tighten mounting screws securely. Failure to do so may result in bodily
injury or damage to the recliner.
NOTE:
For this procedure, refer to
FIGURE 3.1
on this page.
1. Remove back frame with back cushion from its carton.
2. Lock the rear casters. Work from the rear of the recliner base.
NOTE:
Ensure that footrest is in closed position before installing the
back frame with cushion.
3. Lift the chair back in an upright position behind the rear seat cross
brace.
4. Slide the back tubes into the open tube ends of the rear seat cross
brace.
5. Lift the plastic skirt mounted on the bottom of the seat and align
behind the rear seat frame crossbrace
(
DETAIL “A”
).
6. Align the holes in the skirt to the holes in the chair back by fastening
the hardware.
7. Securely tighten the two hex screws to secure the back cushion to
the back frame.
FIGURE 3.1
Assembling the Recliner
DETAIL “A” -
Plastic Skirt
Back Frame with
Back Cushion
Hex Screw
Mounting Hole
Guide Tube
Mounting
Hole
Seat Frame
Mounting Hole
Hex
Head
Screws
Guide Tube
Mounting Hole
Hex Screw
Rear Seat Frame
Crossbrace
Plastic Skirt
Hex
Head
Screws
Plastic
Skirt
Rear Seat
Frame
Crossbrace