ASSEMBLY INSTRUCTIONS
NOTE: The Knee Walker is a mobility device
to be utilized during your recovery from foot or
ankle surgery or injury. If you don’t understand
the manual, please contact your local healthcare
provider for assistance. Failure to do this may
result in injury.
Step 1: To Assemble Knee Walker Frame
- Unpack the Knee Walker from the carton.
- Rotate the lever clockwise to tighten the quick
release clamp and pull the quick release clamp
down to point towards the frame tubing to lock
it securely.
Step 2: To Raise the Steering Tiller
Push the steering tiller upward until it’s fully in
the straight position.
Then, rotate the lever clockwise to tighten the
quick release clamp and pull the quick release
clamp up to lock the steering tiller in the
upright position. (clockwise to tighten, counter
clockwise to loosen)
<Step 1, 2 & 3>
Step 3: To Adjust Height of Handlebars
Handlebars should be set at wrist level to keep
your back straight.
- Remove star screw.
- Extend handlebars up to desired height, align
holes in tiller.
- Then, insert star screw through the steering
tiller.
- Tighten knob securely. (Figure A)
(Figure A)
Step 4: To Adjust Height of Knee
Platform:
- Remove star screw.
- Insert the knee platform post.
- Extend the knee platform to desired height.
- Then, insert star screw and tighten knob
securely.
<Step 4>
