1. Clip the body pack transmitter to your belt or guitar strap.
2. Connect the lavaliere microphone, headset or instrument adapter cable to the body-pack transmitter.
3. Select the transmitter to the right frequency.
4. Turn the transmitter POWER switch ON and MUTE switch OFF.
5. Check the RF Signal Indicator on the receiver to see if the RF signal is being received.
6. Begin speaking or playing your instrument.
7. During the performance or presentation, slide the MUTE ON/OFF switch to the ON position when the system is not being used.
8. When the performance or presentation is over, slide the transmitter MUTE ON/OFF switch to ON position and Power ON/OFF
switch to the OFF position to conserve battery power.
3. Insert two 1.5VAA alkaline batteries into the battery compartment. Two fresh 1.5V alkaline batteries should typically provide 8
hours of performance time. Two fully charged 1.2V Nicad batteries (1800 mA) should provide 12 hours of performance time.
When the LOW BATTERY light on the transmitter turns on, you have 20 minutes of less of useful battery life remaining.
Change the battery at you first opportunity.
IMPORTANT:
Carbon-zinc and zinc-chloride will not provide adequate power and are not recommended.
4. Slide the battery cover back onto the mic body.
1. Slide the transmitter Power ON/OFF switch to the OFF position.
2. Pull up on the OPEN side of the battery compartment cover, flip it open, as shown in FIGURE 8.
3. Insert fresh 1.5VAA alkaline batteries into the battery compartment as shown in Figure 8. Two 1.5VAA batteries should provide 8
hours of performance time. When the red LOW BATTERY light on the transmitter glows, you have 20 minutes or less if useful
battery life remaining; change the battery at your first opportunity.
Operating Body-Pack Transmitters
NOTE:
The body-pack system is designed for use with other equipment, such as lavaliere microphones, guitars, headset
microphones, etc. Contact your dealer for details on ordering the proper equipment for your needs.
Transmitter Battery Installation (FIGURE 8)
IMPORTANT:
Carbon-zinc and zinc-chloride batteries will not provide adequate power and are not recommended.
4. Slide the battery cover back onto the body-pack transmitter.
3. Select the transmitfer to the right frequency
4.
5.
6.
7.
8.
PAGE
4
OFF
OFF
FIGURE
5
Operating the Hand Microphone Transmitters (FIGURE 6)
1. Press the Power ON/OFF switch on the receiver to the ON postion.
2. Slide the transmitter POWER ON/OFF switch to the ON position. Check the battery level. If the LOW BATTERY indicator is lit,
Change the batteris. (see Transmitter Battery Installation below. )
3. Select the transmitter to the right frequency
4. Check the RF indicator on the receiver to see if the radio signal is being received.
5. If the RF light is lit, begin speaking or singing.
6. When the performance or presentation is over, slide the transmitter Power ON/OFF switch to OFF position, to conserve battery
power.
Transmitter Battery Installation (FIGURE 7)
1. Slide the transmitter Power ON/OFF switch to the OFF position.
2. Take off the transmitter battery cover to expose the battery terminals.
(FIGURE 5)
PAGE
3
FIGURE
6
FIGURE
7
VOL
VOL
CHA
CH4
CH3
CH2
CH1
RF
AF
RF
AF
CHB
CH8
CH7
CH6
CH5
POWER
VOL
RF
AF
CH4
CH3
CH2
CH1
WIRELESS MICROPHONE
RECEIVER
