PROALL G Series, Operator'S Manual

Page: 40 / 59

MX05001
6-8
Rev.
1
3 March 2022
1. Using a scraper, remove any excess material
from the discharge end of the conveyor belt.
2. Roll up the cement drop tube.
Figure 16. Cement drop tube.
3. Close the conveyor enclosure.
4. Run the mix auger until it is empty.
Adjust the mix auger speed control to reduce
the auger speed as required.
5. With the mix auger still elevated, ensure that
back plate and sides of the auger trough are
free of build-up. Often the mix auger will be
run in either forward or reverse to facilitate
cleaning of the auger hopper area.
6. Switch the mix auger control to ‘OFF’.
7. Open the mix auger cover and lower the
auger as far as possible.
8. Elevate mix auger to transport position. The
retaining lock will automatically engage.
IMPORTANT: Check for proper alignment as the
auger is being raised
9. Master switch in the display box, or if
equipped with an engine, in the engine
enclosure - OFF
Chain Oiler
The chain oiler consists of the chain oil reservoir
and lubrication solenoid valve and is located
between the gussets on the right-hand side of the
mixer at the rear of the aggregate bin. The chain
oiler keeps the conveyor and cement bin sump
auger chains lubricated and runs automatically
when the chain oiler switch is on. The chain oiler
does not require adjustment but should be
inspected periodically to ensure the reservoir has
oil.
NOTE: Use SAE 30 W oil or similar when filling the
reservoir.
Figure 17. Chain oiler reservoir. (1) oil reservoir,
(2) oil solenoid valve.
WARNING
Never run the mix auger with the top or
bottom cover open.
1
2