2
Gold Pan-Tilt Head Setup
Attach the Gold Pan-Tilt Head to the camera
mounting platform of your camera crane. You
may install it “over slung” (above the
mounting platform) or “underslung” (below
the mounting platform) as per your shooting
needs. Use the 3/8”-16 knob bolts to mount
head to the platform and secure it properly.
Attach the head cable to the cable connected
to the gold pan tilt head for panning & tilting.
If the joystick control is opposite, undo the
connectors at the motors, rotate 180 degrees
and re-install.
HEAD CABLE
Loosen the allen bolts and adjust the length
of the camera platform according to
requirement.
Attach 4-pin power cord male connector from
the Control Cable to the female connector on
the pan mount near the pan motor.
NOTE: Any 12 volt battery may operate the
PROAIM GOLD PAN TILT HEAD as long as the
connector mates and is #1 pin Negative and #4
pin Positive.
CAUTION: DO NOT USE AN UNREGULATED POWER SUPPLY! IF USING A REGULATED POWER SUPPLY IT
MUST PRODUCE LESS THAN 12 VOLTS. MORE THAN 24 VOLTS MAY CAUSE PERMANENT DAMAGE
Install the 12 volt DC power (4-pin XLR) in
rear of Joystick Box.
