PROAIM CINEMA P-SWCC-10 Assembly Manual Download Page 6

6

 

 

NOTE: 

Kindly check the gap between rope & wheels for proper functioning of Cable cam. In case, there is 

a gap between the rope & wheel, please minimize it by adjusting the motor clamp.

 

To do the same, unscrew the Motor Clamp bolts with an Allen key on both sides as shown in the 

 

image.

 

Now, slide it upwards to maximum vertical position. Screw the bolts again on both sides by using the 

 

Allen key. The gap will be minimized & now, the rope will have a better grip on wheels.

 

Wireless Remote Controller & Antenna

 

Precautions!

 

Read the safety messages listed below before operation!

 

• 

Do not use the product at night or during bad weather conditions, like rain or thunderstorms. It can 
cause erratic operation or loss of control

.

 

• 

Do not use the product when visibility is limited.

 

• 

Do not expose the product to rain or snow. Any exposure to moisture (water or snow) may cause  

 

    erratic operation or loss of control.

 

• 

Interference may cause a loss of control. Therefore, to ensure the safety of you and others, do not use 
it in the following place.

 

 

Near any site where other radio control activity may occur. 

 

 

Near people or roads. 

 

 

On any pond/ lake when passenger boats are present. 

 

 

Near power lines or communication broadcasting antennas.

 

• 

Do not use this product when you are tired, uncomfortable, or under the of Alcohol or drugs. Doing so 
may cause serious injury to yourself or others.

 

• 

The 2.4GHz radio band is limited to line of sight. Always keep your model in  sight. Always keep your 
model in sight as a large can block the RF signal and  lead to loss of control.

 

• 

Never grip the transmitter antenna during operation. It significantly degrades Signal quality and 
strength and may cause loss of control.

 

Summary of Contents for CINEMA P-SWCC-10









Reviews: