User Instructions
Using your appliance
To operate the dishwasher:
1. Make sure the water inlet and drain hoses are correctly and securely connected.
2. Push the door release button to open the door.
3. Fill the detergent, water softener and rinsing aid to the dishwasher.
4. Draw out the lower and upper basket. Load the dishes on the dish rack and cutlery inside the cutlery
basket. Make sure that the rotating spray arm can turn freely all the way round. If necessary remove
any obstacles.
5. Close the door firmly. Open the water supply.
6.
7. The dishwasher is designed to stop if the door is opened accidentally during operation.
8. The dishwasher stops automatically at the end of the program. You will hear 8 sec. buzzer sound. The
power pilot light will remain illuminated until the power is switched off.
9. After washing, dishes should be allowed to cool down for about 15 minutes as they are hot to handle.
Dishes will cool quicker if the door is opened slightly.
10. Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
11. After unloading the dishes, remove and clean the filter and return to its position.
Note:
This is normal when you noted small amount of water being pumped-out from the drain hose prior
to the start of a wash cycle. This is because the pump retains a small amount of water from the previous
cycle.
Program Selection Change
You can modify the washing program when the dishwasher just runs for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled.
Delay function
After selecting the wash cycle program, you can set the desired delay start time by pressing the delay
button. You can select 3h/6h/9h from the program. The dishwasher will start operation after the selected
delay time is elapsed.
When you press the start/reset button more than 3 seconds, you can cancel the running
programme and select other programmes .
When you select Intensive/Normal/Eco.Programmes, you can select the All in1 function.
The Display window shows the state of the dishwasher:
a) Running indicator light is off ----------------------------------> stand by;
b) Running indicator light is on and not blinking -----------> pause;
c) Running indicator light is on and blinking ------------------> run.
Note:
If you open the door during a wash cycle, the machine will pause. The running indicator
light will stop blinking and the buzzer will mooing every minute unless you close the door.
After you close the door, the machine will keep on working after 10 seconds.
Press the ON/OFF button, and the ON/OFF light will turn on. Turn the program knob to select a
desired wash cycle, press the Start/Reset button, the machine will work after 3 seconds.
15
