Proaction A105QS, Installation & User'S Instructions

Page: 12 / 19

1. Loading
a: Open the door, place laundry item by item
into the washing machine, firmly close the door.
b:
Do not overload the washing machine (see the
program selection guide for maximum load
information, page 8).
2. Add detergent
Pull out the detergent drawer, add the detergent
and softener to the correct compartments.
3. Select a washing program
a: Adjust the program knob to a program you
desire.(Page 8)
b: The program ready light will be on.
4. Function buttons
Select the 'no spin' or 'cold wash' settings as
required (see page 6).
5. Start washing
Press the start/pause button and the washing
machine will start.
6. Finish washing
a:
Your machine will automatically stop when the
program you have selected ends.
b: The program end light will be on.
c:
Turn the program knob to O(off) position.
d: The door will be unlocked approximately two
minutes after the program ends.
e: You can open the door by pulling the handle
of the door towards yourself and take out your
clothes.
f:
After you unload your clothes leave the door
open to dry the interior of your machine and to
prevent mould from developing.
g: Unplug your machine from the mains power
supply.
h: Close the water tap.
7. Changing a selected program
If you have selected a program and you do not
want it to continue:
a: Press the start/pause button.
b:
Bring the program knob to O(off) status.
c: Adjust the program knob to the program you
desire.
d:
The program ready light will be on.
e: By pressing the start/pause button, run the
program that you have selected.
Note:
If you want to change running program, O
position should be used. Bringing the program
knob to another position will not change running
program.
8. Cancellation of a program
If you wish to end a running program early:
a: Press the start/pause button.
b:
Turn the program knob to O(off) status.
c: Turn the program knob to “Draining” or
“Spinning” program.
d:
The program ready light will be on.
e: Run the program you have selected by
pressing the start/pause button.
Note: If the power is interrupted at any stage of
the washing program, your machine will
continue the program from the point where it
was interrupted. Provided no changes have
been made to the program selected.
Child Lock
Child lock is used in order to protect the
washing cycle from the effects of unwanted
button activations during the cycle. Child lock is
activated by pressing the first and third button
on the control panel at the same time for more
than 3 sec. When child the lock is activated,
LED’s on the function buttons blink to indicate
that child lock is active. In order to deactive child
lock, the same buttons (1st and 3rd) should be
pressed again for more than 3 seconds.
Deactivation of child lock is shown by blinking of
LED on Start/Pause button.
User Instructions
Customer Helpline: 0845 600 4632
Using your washing machine
11