CONNECTING AND OPERATING
How to Connect the HDMIIPLR
HDMI Over CAT6 Extender
Many Sources to Many Displa
ys Function
1.
Connect one HDMI Cable between the HDMI output port of source
device and the HDMI input port of Transmitter unit.
2.
Connect one HDMI Cable between the HDMI input port of display and
the HDMI output port of Receiver unit.
3.
Connect one 100Ohm CAT6 cable between the RJ45 of each
Transmitter unit and RJ45 port of Gigabit Ethernet switch hub.
4.
Connect one 100Ohm CAT6 cable between each RJ45 port of Gigabit
Ethernet switch hub to RJ45 port of Receiver unit. User can select
source channel by setting up dip switch on each transmitter unit. And
select display source for Receiver units via one remote control.
5.
Connect 5V DC power supplies to all Transmitter units and
Receiver units.
6.
Use remote control to select the channel of the desired transmitter to
change sources.
Note.
1.
IR Function is able to receive signal from remote control of your
DVD player and remote control given along with our Receiver unit.
2.
As our Transmitter unit can support over 200 IP address for
different receiver unit, it can connect up to 200 pcs Receiver units.
3.
As each Transmitter has 4 ports of dip switch, it is able to create 16
combinations to define 16 source channels. Therefore, user can
connect at most 16 Transmitter to the system. See Appendix A for
selecting Transmitter channel.
4.
Please note that the Ethernet switch hub should be Gigabit Ethernet
switch hub and has IGMP function.
Please refer to following diagram on the next page: