PROGRAMMING THE THERMOSTAT
7
Temporary and Permanent Hold Feature
Temporary hold:
The thermostat will display
HOLD
and
RUN SCHEDULE
on the bottom of your screen
when you press the
or key. If you do nothing,
the temperature will remain at this setpoint for four
hours. Your program setpoint will then replace your
temporary setpoint.
Permanent hold:
If you press
HOLD
key at the bottom
of your screen, you will see
HOLD
appear next to the
setpoint temperature in the display. The thermostat will
now permanently stay at this setpoint and can be
adjusted using the or keys.
To return to program:
Press the
RUN SCHEDULE
key
at the bottom of your screen to exit either temporary or
permanent hold.
Filter Change Reminder
If your installing contractor has
configured the thermostat to remind you
when the air filter needs changed, you will
see
FILT
in the display when your air filter
needs changed.
FILT
will be shown in the
display after your system has run long
enough to require an air filter change.
Resetting the filter change reminder: When
FILT
reminder is displayed, you should
change your air filter and reset the reminder
by pressing the
CLEAN
key for 3 seconds.
FILT
will leave the display when reset.
Next Zone
The
NEXT ZONE
key cycles through all
zone thermostats connected to your wireless
zoning system.
LOCAL
shows the ambient temperature of
the
Master Thermostat
only.
The name of each zone thermostats
will show and the ambient temperature for that
zone only will be displayed.
For more information,
see the Zone Thermostat User Guide.
Hold down
CLEAN
for 3 seconds,
to reset filter reminder.
Living ROOM
