PROGRAMMING THE THERMOSTAT
5
Temporary and Permanent Hold Feature
Filter Change Reminder
If your installing contractor has configured
the thermostat to remind you when the air
filter needs changed, you will see
FILT in the
display when your air filter needs changed.
FILT will be shown in the display after your
system has run long enough to require an air
filter change.
Resetting the filter change reminder: When
FILT reminder is displayed, you should
change your air filter and reset the reminder
by holding down the second button from the
top left side of the thermostat for 3 seconds.
Temporary hold:
The thermostat will flash
HOLD on the left of your screen when you
press the or key. If you do noth-
ing, the temperature will remain at this
setpoint temporarily until the next program
period begins. Your program setpoint will
then replace your temporary setpoint.
Permanent hold:
If you press
HOLD/RUN,
you will see
HOLD/RUN appear below the
setpoint temperature in the display.
The thermostat will now permanently stay at
this setpoint and can be adjusted using the
or keys.
To return to program:
Press
HOLD/RUN to
exit either temporary or permanent hold.
Hold down
PROGRAM and TIME
for 3 seconds to reset filter reminder.
