Troubleshooting
9
Fault
Power LED doesn’t light up
No video is displayed on
the monitor
Poor picture quality or
intermittent video play
No audio
Solutions
●
Check the battery mounted is available.
●
Check the power plugs of TX and RX are
properly connected to a functioning power
outlet.
●
Verify that the proper cable has been
selected and installed between the TX input
and your SDI output.
●
Make sure your camera connected with TX
has been powered.
●
Select the right SDI or HDMI video source
on the monitor when connect to RX.
●
Check your video resolution with SDI input
from your device is 1080P, 1080i, 720P, 576i
or 480i.
●
Check VIDEO LED and NET LED on your TX;
if VIDEO LED doesn’t light up, check the
input signal; if VIDEO LED lights up, but NET
LED doesn’t light up, check TX/RX antennas
installation and their directions.
●
Ensure transmission distance is not over
300m (LOS).
●
Check your video resolution with SDI input
from your device is 1080P, 1080i, 720P, 576i
or 480i.
●
Check TX/RX antennas installation and their
directions.
●
Ensure transmission distance is not over
300m (LOS) and there’s no interference
between TX and RX.
●
Shutdown and restart the set.
volume is properly set and not in “MUTE”
mode.
●
●
Shutdown and restart the set.
Check your monitor or other equipment’s
Summary of Contents for XW-HDU04J
Page 1: ...XW HDU04J XW HDU04JR XW HDU04J XW HDU04JR ...
Page 13: ......
