Thank you for purchasing a
our PAR710
. These Moving head will
provide you will years of trouble free service and allow you to be far
more flexible and innovative due to their color mixing capabilities, low
power consumption, and the variety of control options.
To optimize the performance of this product, please read these
operating instructions carefully to familiarize yourself with its basic
operations. These instructions contain important safety information
regarding the use and maintenance of this unit. Please keep this
manual for future reference.
Safety and Proper Use
0 When unpacking and before disposing of the carton check
there’s no transportation damage before using the projector.
Should there be any damage caused by transportation,
consult your dealer and do not use the apparatus.
0 The projector is for indoor use only, IP20. Use only in dry locations.
Keep this device away from rain and moisture, excessive heat,
humidity and dust. Do not allow contact with water or any other
liquids.
0 DO NOT mount the projector directly onto in ammable surface
0 The projector is only intended for installation, operation and
maintenance by qualited personnel.
0 The projector must be installed in a location with adequate
ventilation, at least 50cm from adjacent wall surfaces. Be sure that
no ventilation slots are blocked.
0 Do not project the beam onto in ammable surfaces, minimum
distance is 5m
0 Avoid direct exposure to the light from the lamp. The light is
harmful to the eye. Do not attempt to dismantle and/or modify the
projector in any way.
0 Electrical connection must only be carried out by qualited
personnel.
0 Before installation, ensure that the voltage and frequency of power
supply match the power requirements of the projector. It is
essential that each projector is correctly earthed and that electrical
installation conforms to all relevant standards.
0 Keep a projector’s optical system clean. Do not touch LED lens with
bare hands.
0 The projector should always be installed with a secondary safety
. A safety cord is supplied for this; it should be attached as
shown in “installing the projector” section.
0 Shields and lens shall be changed if they have become visibly
damaged to such an extent than their effectiveness is impaired, for
technician before replacement. The projector has thermal protection
device that will switch off the projector in case of overheating, should this
occur, check if the fans work normally or fan and fan shield are blocked by
dust. If the projector not operational, call a qualited technician. After
cleaned and repaired, the projector can be restarted.
Any maintenance work should only be carried out by qualited
technicians.
KEEPING THE PROJECTOR CLEAN
It denitely necessary to keep a projector clean for its reliable
use. Cooling fans and their shield should be cleaned every
15days. LED lamps’lens and cover should be cleaned regularly
for optimized light output.
Cleaning frequency depends on how often a projector is used and
its operational environment. A soft cloth and typical glass cleaning
products should be used in cleaning. It is recommended to clean
the external optics at least once every 20 days.
Do not use any organic solvent, e.g. alcohol, to clean t housing of
the apparatus.
Troubleshooting
PROBLEM
ACTION
The projector can’t be started
> Power Cable not connected well
> Power supply damaged or not
connected well, a quali
ed
Technician should be required
> Control board not connected well
and a quali
ed
Technician should be
The lamp can be started, but
LED lampsare off and not
controlled
> LED boards not connected
properly, a quali
ed
technician is
needed
A projector’s lamps are on
but it doesn’t respond to the
controller
> Make sure that the projector’s start
address is correctly set
> Replace or repair the DMX cable.
The beam appears dim and
Its brightness slows sharply
> Ambient temperature too high
which result in a projector
overheating, necessary ventilating
measures needed.
