3.1 GENERAL
The Hybrid Spot welder is inspected and tested prior to leaving the factory to guarantee consistent
quality and the highest possible reliability. Follow the installation tips and operating instructions below
to ensure user safety and proper welder performance.
WARNING! Do not operate or place the welder
near water, in wet locations or outdoors. Risk for
injuries or damage to the welder.
WARNING! Do not place the welder on unstable
or uneven ground. The welder might fall causing
personal injuries and damage to the welder. Do
not operate on a slope of more than 10°.
IMPORTANT! It is the responsibility of the owner
to ensure that the equipment has been installed
as specified in the instructions provided. It is also
the owner’s responsibility to ensure that the
welder is inspected in accordance with
applicable regulations before it is put into
service. Do not use for thawing out frozen water
pipes (17.1).
A grounded electrical plug must be installed (refer to section 3.4 “ Connection of electrical supply”).
3.2 PACKAGING AND DELIVERY INSPECTION
Check the contents of the shipping container against the packing list, consignment note, or other
delivery documentation to verify that everything is included and in the correct quantity. Check the
Spot Welder carefully to make sure that no damage has occurred during transport. If anything is
damaged or missing, the welder may be unsafe to use until the part is repaired or replaced. If anything is
missing, please contact your supplier. Remove all packaging material from the welder.
3.3 WELDER ASSEMBLY
Insert the support arm (boom) as shown in Figure 3.1
INSTALLATION
3.0
ATTENTION! Ne pas faire fonctionner le soudeur
prés de l’eau, en voie humide ou à l’extérieur.
Risque de blessures ou de dommages au
soudeur.
ATTENTION! Ne placez pas le soudeur sur un sol
instable ou irréguiliére. Le soudeur peut tomber
causant des dommages graves au soudeur. Ne
pas utiliser sur une pente de plus de 10°.
IMPORTANT! C’est la responsabilité du propriét-
aire de s’assurer que l’équipment a été installé
comme specifie dans les instructions fournies.
C’est aussi la responsabilité du proprietaire de
s’assurer que le soudeur est inspecté conforment
à la réglementation applicable avant qu’il ne soit
mise en service. Ne pas utiliser pour dégeler les
conduites d’eau congelées (17.1).
Figure 3.1
All Info Copyright © Pro Spot International Inc.
10