Connect a 1:1 balun (suggested) using two short wires, not longer than 8-10 cm or 3-4 inches
(connctions wires will influence the antenna tuning making it longer), if you don’t use a balun, than
use a coax cable choke, open the coax ends to have two short leads like a V no longer than 3-4 cm
or 1-2 inches, soldering on them two eyelet ends. Don’t forget to insulate and seal coax end from
moisture. (If you don’t have any sealing liquid, use nails painting and when dry, cover with good
rubber tape)
(Balun and eyelet ends are optionals not included in the antenna parts)
Balun or coax choke do not improve antenna performance, but reduce the RF presence on the coax
shield reducing the risk of TVI or other RF noise on electronic devices.
When assembled antenna will looks like the one in the picture below.
SWR main diagram
Summary of Contents for PST-32
Page 2: ...Assembling dipole and reflector ...
Page 3: ...main antenna diagram ...
