Lock bolts of isolators and assembling the RF choke coil (choke). Making sure that the coil is
vertical for a better rain drainage. The choke will short to ground any electrostatic discharge and
will reduce noise.
The care and precision of this assembly will ensure a long life to the antenna.
Check that all bolts have been properly secured and completed the radiator assembly.
With the aid of the U bolts, install the base on the supporting pole and install the wire radials.
The U bolts are 50mm wide, it can get poles or tubes from 40 to 50mm.
As radials being installed, take care doing the work as they can also heavily influence the final
tuning. You may have to try to attempt the best point of risonance.
Antenna alluminum main tubes:
1 x 30x1150mm
1 x 25x1150mm
1 x 20x1150mm
1 x 26x1150mm
1 x 12x1150mm (4 holes allow the fine tuning)
2 x 5,25m wire radial (installing more radial will improve antenna performance)
WARNING!!
All images and drawings, in this user manual, are indicative, with the sole purpose of helping
the assembly, they may not explain exactly the product, which may be subject to changes
without obligation to anyone, without prejudice to the final specifications.
Due wire radials antenna will have greater performance if installed 10-20cm over the ground with
radial on the soil or roof. If the space is not enought for a complete wires extension, they can be
coiled on the ground around the antenna base in a spiral-shaped design.
Before to rise up antenna in the sky, make sure that all bolts and connections are well tightned.
Do not seal tubes joints. Antenna must breathe.
