IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
•
Check that the voltage indicated on the PSU rating plate corresponds with that of the
local network before connecting to the mains power supply.
•
Do not expose to excessive heat or locate where damp or moisture may enter the
device.
•
Ensure there is sufficient ventilation to allow any generated heat to dissipate.
OVERVIEW
•
This device can extend one HD source to a display or projector using CAT5e or CAT6
cables.
•
The extending distance is up to 150m.
•
Supports 24/50/60fs/1080p/720p/576p/576i/480p/480i CEC modes.
•
Audio formats supported DTS-Dolby/Dolby trueHD/LPCM7.1/DTS/Dolby-AC3/DSD.
WHAT’s IN THE BOX
•
HDMI Transmitter
•
HDMI Receiver
•
5V DC Power Supply x 2
•
IR Transmitter
•
IR Receiver
•
4 Mounting brackets and screws
•
User’s Manual
INSTALLATION
•
Please make sure all devices you wish to connect have been powered off.
•
Connect the source device to the transmitter using appropriate HDMI cable up to 10m.
•
Connect premium CAT5e/6 cable up to 150m long to the output of the transmitter and
to the input of the receiver.
•
Connect the IR RX to the IR Input jack on the receiver.
•
Ensure the IR receiver is located where it is visible to the source device remote
control unit.
•
Connect the IR TX to the IR Output jack on the transmitter and direct the IR sender
towards the source device remote control sensor.
•
Connect the HDMI output using appropriate HDMI cable up to 10m long to the display.
NOTE:
Premium quality HDMI and CAT6 leads must be used to achieve the maximum
audio/video quality and stability over greater distances and for 1080p resolution.
•
Connect the DC side of the 5V power supplies to the transmitter and the receiver then
connect the AC side of the power supplies into the mains supply.
•
The red LED lights when the power is applied.
•
Power on the source device and the display.
•
The device reads the output display EDID information and adjusts output accordingly
and reads incoming TMDS data and optimises the signal for the devices attached.
NOTE:
If using the supplied mounting brackets, only use the two threaded holes on each
side of the case to attach the brackets.
2
