V1.0
Air Needle Scaler
8843625
Visit www.princessauto.com for more information
5
1. Use the correct tool for the job. This tool was designed for a specific function.
Do not modify or alter this tool or use it f
o
r an unintended purpose.
2 Avoid unintentional starts. Be sure that the throttle/ignition switch is in neutral
or OFF position when not in use and before connecting it to any air source. Do
not carry the tool with fingers near or on the lever.
AIR TOOL PRECAUTIONS
1. Use only clean and dry compressed air as a power source. Contaminated or
moist air will gradually damage the tool.
2. Install an in-line shutoff valve or regulator to allow immediate control over the
air supply in an emergency, even if a hose is ruptured.
3. Discontinue tool use if it does not work properly or air is leaking. Tag or mark
the tool as ‘defective’ or ‘out of service’ until repaired.
4. Check the manufacturer’s maximum pressure rating for air tools and
accessories. Compressor outlet pressure must be regulated to never
exceed the maximum pressure rating of the tool (see Specifications).
Exceeding the maximum PSI rating can create a bursting hazard, causing
injury and property damage.
5. Attach all accessories properly to the tool before connecting the air supply. A
loose accessory may detach or break during operation.
6. Never use oxygen, combustible gas or any other bottled gas as a power
source. Any power source other than an air compressor could cause an
explosion and serious personal injury.
7. Turn OFF the valve and discharge any remaining air pressure after each use
or before adjusting the tool.
8. Do not leave the air tool unattended with its compressed air supply on. Turn
off the compressed air supply and bleed the air tool of any remaining
compressed air before leaving the air tool unattended.
9. Serious injury may occur from loose debris being propelled at high speeds
from the compressed air stream. Always wear OSHA approved safety glasses
to protect the eyes during operation of the air compressor.
10. Always turn off the air compressor and drain tank pressure completely before
attempting maintenance or attaching air tools. Release pressure slowly from
the system.
11. Serious injury or death may occur from inhaling compressed air. The air
stream may contain carbon monoxide, toxic vapors or solid particles. Never
inhale compressed air directly from the pump or air tool.
