Pro-Line Boats PRO-MT 4x4, User Manual

Page: 3 / 16

3
FIG. C
Remove support only if
using 1:8 Motor. If using
550 motor, leave in place.
FIG. D
For motors with a 3mm
shaft, use included Pinion
Reducer (#4005-50) as
shown.
1
Remove Sentinel body
by unscrewing four
Secure-Loc caps.
GETTING STARTED: INSTALL ELECTRONICS
FOAM
FOAM
FOAM
LIPO BATTERY
2S, 3S, OR 4S
MAX BATTERY SIZE
(mm)
145 x 51 x 55
(L x W x H)
2
INSTALL LIPO BATTERY
1. Use the included
adhesive foam
spacers to position
your battery (if
necessary, depending
on size) as far
forward and to the
centerline of the
chassis as possible.
2. Secure battery with
Velcro straps.
4
INSTALL ELECTRONIC
SPEED CONTROLLER
1. Secure ESC to
chassis using high-
quality double sided
tape (servo tape).
2. Feed ESC wires under
side guard clips to
receiver.
MOTOR
5
INSTALL MOTOR
1. Remove four M3 × 10
bottom screws to
detach motor mount.
See Figure B.
2. If using 1:8 motor
(42mm diameter),
remove motor
support. See Figure C.
3. Select the correct
gear mesh inserts for
your pinion size. See
detailed instructions
for setting gear mesh
on page 4.
4. Attach motor to motor
mount using included
screws: (2) M3
× 10 for
550 size or (2) M4 × 10
for 1:8 size.
5. Install motor mount
assembly onto main
chassis with four
M3
× 10 screws, with
gear mesh inserts.
6. Install pinion gear
(#4005-10A) with
M4x4mm set screw.
See Figure D.
6 INSTALL SERVO
1. Feed servo wire
under center diff to
reach receiver. See
Figure A.
2. Install servo with
four M3 × 10 socket
head screws and M3
washers.
3. Select the servo horn
that matches the
spline count on your
servo.
23: Airtronics, JR, KO
24: Hitec
25: Futaba, Savox, ProTek
4. With radio and
vehicle powered
on and servo at
neutral, install servo
horn parallel to the
connecting arm.
5. Secure servo horn
with screw included
with servo.
3
INSTALL RECEIVER
Secure receiver to chassis
using high-quality double
sided tape (servo tape).
FIG. B FIG. A
PARALLEL
SER
VO WIRE
See a fully-wired,
ready-to-bash PRO-MT 4×4 at
prolineracing.com/pro-mt4x4