Check the operations of your trim tabs before getting underway. To operate the trim tabs locate the trim
tab rocker switches on the console. Press both switches forward and hold them down. This will engage
both trim tabs and will ensure they are working properly while in the full down position.
The switch on the port side operates the starboard trim tab. The switch on the starboard side operates
the port trim tab. To check each trim tab individually, press one of the trim tab rocker switches forward
and check to see if the opposite trim tab goes down. For example if the starboard trim tab switch is being
pressed down, the port trim tab should be going down. Repeat the same process for the opposite side.
While underway and in open water, clear of other boaters, depress the top half of the switches in half-
second increments to achieve the desired degree of trim. To correct a starboard list, depress the top half
of the port switch in small increments until the list is corrected. To avoid over trim, allow a few seconds
between tab adjustments to allow the boat to respond. If you over trim, simply give the over trimmed tab
an adjustment in the opposite direction. Push the top half of both rocker switches in half-second
increments to trim the bow down.
Warning: Trim tabs can cause a dramatic change in the attitude and heading of your
boat. Adjust them in small increments when in open water and clear of any obstructions.
14
