ProLift WM Hybrid - WMHW ASSY Instructions : 0.003
Remove the backing from the
double sided tape and attach to
outer edge of upright
JORO recommends attaching the
Board Backer Supports supplied
Mount the white board
Use the holes which correspond to manufacturers
recommended projector to image distance
Be sure to NOT over tighten
Note, there are drilled/tapped holes on the frame
upright, if lowering the board is required
Fasten using the JORO Button Head screws supplied
Mount the Wire Mgmt Molding
JORO recommends attaching the
Wire Mgmt Moldings supplied
Remove the backing from the double
sided tape and attach to side of frame
upright
Wire Mgmt Molding
Mount the Board Backer Support
Board Backer Support
Lower
drilled/tapped
holes
JORO Button Head
COPYRIGHT 2014
www.proliftstand.com
www.joromfg.com
10
