4
MAINTENANCE PROCEDURES
MAINTAINING OIL LEVEL
Important Note:
Important Note:
When adding or replacing oil, always
use a good grade Hydraulic Jack Oil (or
transmission oil, turbine oil etc.). Avoid
mixing types of oil. DO NOT use Brake
Fluid, Alcohol, Glycerine, Detergent, Motor
Oil or Dirty Oil. Improper fl uid can cause
serious internal damage to Jack.
ADDING OIL:
With saddle fully lowered & jack on level
ground, remove cover plate then open
Oil Filler Plug. Oil level should be approx.
12mm below valve hole. If low, add oil
as needed then close Oil Filler Plug and
replace cover plate.
REPLACING OIL:
For better performance and longevity,
replace oil supply once a year. To drain
oil, remove cover plate, open Oil Filler
Plug and loosen the Release Valve by
applying handle turning counterclockwise.
BE VERY CAREFUL not to permit dirt or
foreign matter to get into the system. Close
Oil Filler Plug and replace cover plate.
SPECIFICATIONS
Working Load Limit: .......................................................................................... 1800Kg
Jack Dimension : .............................................................. 550mm x 210mm x 135mm
Height Lowered : ...............................................................................................135mm
Height Raised : ................................................................................................. 385mm
Oil Capacity : .................................................................................................145+/-5cc
Net Weight : .......................................................................................12.8Kg. (approx.)
210mm
550mm
65mm
40mm
385mm
135mm
