1
2
3
4
5
6
7
8
9
10
11
12
13
Remove the counterweight and anti-skating weight from the
tonearm. Secure the tonearm using the supplied red wire.
Remove the main platter.
Bring the turntable in an upright position to have access to
both the upper- and underside.
Underside: remove upper screw while holding the tonearm
from the other side.
Loosen the lower screw just a little to be able to
rotate the RCA box.
Carefully rotate the RCA box...
... until the 5.5mm nut is accessible.
Using the PH1 and 5.5mm nut wrench, loosen the tonearm
(base) by 3mm.
Loosen the upper nut by 3mm.
Check if the gap is sufficient.
Slide in the VTA spacer from behind until the spacer
is flush with the arm base.
Tighten both nuts. Please make sure to hold the
antiskating support with your finger while doing so.
14
16
Rotate the RCA box back to the initial position.
Tighten both screws.
Remove the red securing wire and re-install
counterweight and anti-skating weight.
Reseat main platter.
15
