© Pro-Ject Audio Systems · Measure it E · Revision 02.09.16
Backlight
Turn on the stylus balance and the backlight will automatically switch on (no further key switch
needed). When the stylus balance is switched off, the backlight will switch off.
Other display readouts
No display, backlight getting weak - batteries are empty and need to be replaced.
o_LD
- overload (more than 5g). Please remove the excessive load immediately.
LLLLL
- The weighting load cell has been damaged by misuse (i.e. it was shocked, dropped or
overloaded). You can try to recalibrate the meter. If the load cell has not been damaged to
much, it will work again after recalibration.
UNSt
- Use the meter on a more stable, vibration free surface.
Changing batteries
Proceed as follows:
•
Take off both battery case covers
•
Replace both batteries together. Make sure the batteries are the right way round
•
Refit the battery case covers
Battery type: 2 x LR45 (AG12) button cells, 1,5V
If the stylus balance is not used over a long period of time the batteries should be removed.
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted
batteries at the appropriate collection sites - usually located at supermarkets and
drugstores.
Technical specifications Measure it E
Capacity
0 - 5g
Variance
±0,002g
Weighting modes
gram (1g = 10mN), ounce (oz), pennyweight (dwt) and carat (ct)
Display
4 digit LCD with backlight
Calibration
auto calibration using a 5g weight
Auto off
30 seconds off
Replacement battery
2 x LR43 (AG12) button cells, 1,5V
Operating temperature
+10 - +30
°
C (50 - 86 degrees Fahrenheit)
Dimensions (W x H x D)
96 x 21 x 43mm
Weight
49g
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these
instructions for use. Modification or change to any part of the product by unauthorized
persons, will release the manufacturer from any liability over and above the lawful rights of
the customer.
Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright © 2016. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
