Pro-Ject Audio Systems Box-Design Phono Box ultra 500 Instructions For Use Manual Download Page 4

© Pro-Ject Audio Systems · Phono Box ultra 500 · Revision 2018.10.25 

 

 

 

Stand-By 

The button on the front panel of the unit alternately turns the power on or returns it to standby mode. 
The blue LED above the stand-by push button shows that the unit is switched on. 

 

 
Technical specifications  Pro-Ject Phono Box ultra 

A

 Typical for low output MC cartridges, 

B

 typical for MM or high output MC cartridges 

* Input capacitance is irrelevant for low-output MC cartridges 

Input impedance: 

10, 100, 1k, 47k ohms / 100pF 

Input capacitance / impedance: 

100pF, 200pF, 320pF and 420pF */47kohms

 B

 

Together with other input impedance settings without any 
influence! 

Input gain: 

40 and 43dB

 B

 / 60 and 63dB

 A

 

Signal / Noise ratio MM: 

85dBV (90dBV - 'A' weighted) 

Signal / Noise ratio MC: 

65dBV (71dBV - 'A' weighted) 

THD: 

<0,0005% MM, < 0,004% MC 

RIAA-equalization curve accuracy: 

<0,4dB / 20Hz - 20kHz 

Subsonic filter: 

at 20Hz with 18dB/octave 

Input: 

1 pair RCA/phono sockets 

Line-level output: 

1 pair RCA/phono sockets 

Power supply DC: 

18V/500mA 

Power consumption: 

18V/80mA DC 

Dimensions W x H x D (D with sockets): 119 x 37 x 103 (113)mm 
Weight: 

340g without power supply 

 

Potential incorrect use and fault conditions 

No signal on one or both channels: 
 

No connection between player and phono amplifier or amplifier. This could be due to a faulty plug, 

 

broken wire or solder joint or simply loose plug/socket connection. 

Strong hum: 
 

No earth connection from cartridge or arm, or arm cable to phono amplifier, or earth loop. 

Output too quiet or too loud, or distorted: 
 

Input gain incorrectly set - input overloading or insufficiently amplified. 

Service 

Should you encounter a problem which you are not able to alleviate or identify, please contact your 
dealer for further advice. Only if the problem cannot be resolved there, the unit should be sent to the 
responsible distributor in your country. 

Warranty 

 

The  manufacturer  accepts  no  responsibility  for  damage  caused  by  not  adhering  to  these 
instructions for use. Modification or changes to any part of the product by unauthorized persons 
release the manufacturer from any liability over and above the lawful rights of the customer. 

Copyright, trademarks 

Pro-Ject Audio Systems is a registered Trademark of      
H. Lichtenegger. 

This guide was produced by: Pro-Ject Audio 
Systems 
Copyright 

©

 2018. All rights reserved.

 

The information was correct at the time of going to 
press.  The  manufacturer  reserves  the  right  to 
make  changes  to  the  technical  specification 
without  prior  notice  as  deemed  necessary  to 
uphold  the  ongoing  process  of  technical 
development.

 

 

Reviews: